PRODUCTS  > Double Sided Adhesive Tape  > DS Mesh Transfer Tape

DS Mesh Transfer Tape
bondtape product guide property
Product Guide
Product
Description
Application

DS6025G adopts PET Mesh carrier, coated with solvent acrylic adhesive on both sides, and protected with bronze glassine double-sided silicone release paper.

DS6025G is special designated for foam lamination. It is mainly for foam thermal insulation and cushion in air-conditioning / refrigeration / automobile industry.

It is essential that the user evaluate the BondTape product to determine whether it is fit for a particular purpose and user’s method of application. Good results will be obtained when applied to a clean, dry surface with a suitable pressure on BondTape products between +10 ~ +40°C (+50 ~ +105 °F).

TA6025G without carrier, coated with solvent acrylic adhesive , and protected with bronze glassine double-sided silicone release paper.

TA6025G  is special designated for foam lamination. It is mainly for foam thermal insulation and cushion in air-conditioning / refrigeration / automobile industry.

It is essential that the user evaluate the BondTape product to determine whether it is fit for a particular purpose and user’s method of application. Good results will be obtained when applied to a clean, dry surface with a suitable pressure on BondTape products between +10 ~ +40°C (+50 ~ +105 °F).

Typical Physical Properties
Product
Backing
Adhesive
Thickness Micron
Adhesion N/25mm
Tensile N/25mm
Elongation %
Service Temp°C
PET
solvent acrylic
60
15
40
3.5
-20 ~ +100
Double-sided
solvent acrylic
60
15
--
--
-20 ~ +100

PRODUCT FORM & AVAILABLE SIZE

Log Roll: 1020mm x 45M / 50M                  Jumbo Roll: 1020mm x 1000M / 500M / 250M

IMPORTANT NOTE

1. The data above are typical values only, and should not be used for specifications purpose.

2. Tolerance: Thickness: ±10%; Width: ±3mm; Length: Cut Roll: ±0.3m, Jumbo Roll ±0.5%.

STORAGE & SHELF LIFE:

12 months when stored at 21°C (70°F) / 50% relative humidity out of direct sunlight.

SUGGESTIONS FOR PRODUCT APPLICATION:

It is essential that the user evaluate the BondTape product to determine whether it is fit for a particular purpose and user’s method of application. Good results will be obtained when applied to a clean, dry surface with a suitable pressure on BondTape products between +10 ~ +40°C (+50 ~ +105 °F).